HVAC replacement cost in Plano, TX
Plano's housing boom ran from the 1970s through the 1990s, so a large share of the city is now replacing second-generation systems installed in the 2000s. Most Plano replacements are 3- to 4-ton split systems — a central AC paired with a gas furnace — and two-story homes in west Plano often run two systems or a zoned system. Like most of North Texas, Plano systems work hard: cooling runs eight to nine months a year.
Estimate My Cost Get Free Plano Quotes
What Plano homeowners pay, by system size
Installed prices for a standard-efficiency split system (AC + furnace or heat pump), including equipment, labor, and permit. High-efficiency systems typically add 15–25%.
| System size | Typical installed range |
|---|---|
| 2-ton system | $6,900 – $10,400 |
| 3-ton system | $8,200 – $12,300 |
| 4-ton system | $9,400 – $14,200 |
| 5-ton system | $10,700 – $16,100 |
Ranges reflect typical Plano single-family homes. Ductwork replacement, electrical upgrades, and a second system for two-story homes are extra and should be itemized in any quote.
Permits in Plano
Plano requires a mechanical permit for HVAC system replacement — AC replacement is listed as permitted work with the city. Your installer normally pulls the permit and includes the fee in the quote. In Texas, HVAC contractors are licensed by the state (TDLR), and your contractor should also be registered with the city. Ask to see the permit number on your contract — a contractor who suggests skipping it is a red flag, and an unpermitted install can complicate a future home sale or insurance claim.
Utility incentives in Plano: the Oncor program
Most Plano homes get their electricity delivered by Oncor (you pick a retail electric provider; Oncor runs the wires). Oncor's Home Energy Efficiency program pays an incentive on qualifying high-efficiency AC and heat pump replacements — but the mechanics surprise people:
- The incentive is paid to your contractor, not to you. Only contractors enrolled as Oncor Participating Service Providers can claim it, and they are expected to pass it through as a discount on your invoice.
- The amount is calculated from your system's modeled energy savings, with per-project caps by size — for 2026, caps run from $2,000 for a 2-ton system up to $3,400 for a 5-ton. Most projects land below the cap.
- Funding is limited and the program runs seasonally, roughly February through mid-November, so a participating contractor's status matters more than the headline number. Ask before you sign, and get the incentive shown as a line item.
CoServ pockets: parts of west and north Plano are served by the CoServ electric cooperative instead of Oncor. CoServ currently offers no rebates or incentives for efficiency upgrades, so if CoServ is on your bill, don't let a quote assume an Oncor incentive.
Gas furnace bonus: most Plano homes heat with gas from Atmos Energy. Atmos Mid-Tex pays $300 back on an ENERGY STAR gas furnace rated 90% AFUE or higher, or $350 at 95% AFUE and up — worth claiming when you replace the furnace with the AC.
Note: the federal Energy Efficient Home Improvement Credit (Section 25C) ended for equipment installed after December 31, 2025, so don't let a quote count it as a 2026 saving.
Electricity rates: why efficiency pays in Plano
Texas electricity is deregulated in Oncor territory, so your rate depends on the retail plan you choose — typical all-in residential rates in the Dallas area run roughly 14–17¢ per kWh, with advertised plans ranging much wider (always compare at your real usage on the plan's Electricity Facts Label, via the state's Power to Choose site). Air conditioning is the largest single load in a Plano home, often half of a summer bill, so stepping up from the minimum efficiency can pay back faster here than in milder climates.
Sizing a system for North Texas heat and humidity
Dallas-area design temperatures sit around 100°F, and Gulf humidity means a system also has to remove moisture, not just heat. An oversized unit short-cycles and leaves the house clammy; an undersized one runs flat-out through August. Don't just match the old nameplate: ask for a Manual J load calculation, and have the contractor check attic duct leakage — most Plano equipment sits in the attic, where leaky ducts lose cooled air into 130°F+ attic space.
The working rule of thumb in North Texas is 1 ton per 500–600 sq ft for typical construction. Use our cost calculator for a first estimate, then insist your installer confirms sizing with a Manual J load calculation. Also note the federal floor: new split systems installed in Texas must be at least 14.3 SEER2 (13.8 SEER2 for systems 45,000 BTU and larger), and split heat pumps at least 14.3 SEER2.
Plano HVAC replacement FAQ
How much does it cost to replace an AC unit in Plano, TX?
Most Plano homeowners pay $8,200–$14,200 installed for a full AC and furnace or heat pump replacement, depending on tonnage and efficiency. A 3-ton standard-efficiency split system typically lands around $8,200–$12,300; larger or high-efficiency systems cost more.
Does Plano require a permit to replace an AC unit?
Yes. Plano lists AC replacement as permitted work, and a mechanical permit is required. Your TDLR-licensed contractor normally pulls it and includes the fee in the quote — ask for the permit number on your contract.
Can I get an Oncor rebate in Plano?
Most Plano homes are in Oncor territory, where Oncor's Home Energy Efficiency program pays an incentive on qualifying high-efficiency replacements — but it pays your participating contractor, not you directly, and the contractor applies it as a discount. Ask before you sign whether your contractor participates and get the incentive shown as a line item. Some Plano addresses are served by CoServ instead, which currently offers no efficiency rebates.
Is my Plano home in Oncor or CoServ territory?
Most of Plano is Oncor (you choose a retail electric provider, and Oncor delivers the power). Pockets of west and north Plano are served by the CoServ electric cooperative instead. Your electric bill tells you which: if it shows Oncor delivery charges, you are in Oncor territory and the Oncor incentive can apply.
Compare costs in nearby cities
See our other Dallas–Fort Worth guides: Frisco, Irving, Arlington, Garland. Or go back to the national cost overview.
Get free quotes from Plano installers
Tell us about your project and local HVAC partners will contact you with itemized quotes. No obligation.