HVAC replacement cost in Frisco, TX
Frisco is one of the fastest-growing cities in the country, and more than 80% of its homes were built after 2000 — which means the original systems in the big 2005–2012 subdivisions are now reaching end of life together. Frisco homes are larger than the DFW average, and most two-story homes run two systems, one per floor. The prices below are per system.
Estimate My Cost Get Free Frisco Quotes
What Frisco homeowners pay, by system size
Installed prices for a standard-efficiency split system (AC + furnace or heat pump), including equipment, labor, and permit. High-efficiency systems typically add 15–25%.
| System size | Typical installed range |
|---|---|
| 2-ton system | $7,000 – $10,500 |
| 3-ton system | $8,300 – $12,400 |
| 4-ton system | $9,500 – $14,300 |
| 5-ton system | $10,800 – $16,200 |
Ranges reflect typical Frisco single-family homes, per system. Replacing two systems, ductwork replacement, and electrical upgrades are extra and should be itemized in any quote.
Permits in Frisco
Frisco requires a mechanical permit for HVAC system replacement — AC replacement is listed as permitted work with the city. Your installer normally pulls the permit and includes the fee in the quote. In Texas, HVAC contractors are licensed by the state (TDLR), and your contractor should also be registered with the city. Ask to see the permit number on your contract — a contractor who suggests skipping it is a red flag, and an unpermitted install can complicate a future home sale or insurance claim.
Utility incentives in Frisco: check your bill first
Frisco is split between two electric providers, and which one serves your street decides whether any utility incentive exists for your replacement:
- Oncor addresses (you choose a retail electric provider; Oncor delivers the power): Oncor's Home Energy Efficiency program pays an incentive on qualifying high-efficiency replacements. It is paid to participating contractors — not to you — and applied as a discount on your invoice. Amounts are based on modeled energy savings, with 2026 per-project caps from $2,000 (2-ton) to $3,400 (5-ton); most projects land below the cap, and funding is limited.
- CoServ addresses (the electric cooperative bills you directly): CoServ currently offers no rebates or incentives for efficiency upgrades. If CoServ is on your bill, don't let a quote assume an Oncor incentive.
Gas furnace bonus: most Frisco homes heat with gas — split between CoServ Gas and Atmos Energy. Only Atmos customers qualify for the Atmos Mid-Tex furnace rebate: $300 back on an ENERGY STAR gas furnace rated 90% AFUE or higher, or $350 at 95% AFUE and up, when you replace the furnace with the AC.
Note: the federal Energy Efficient Home Improvement Credit (Section 25C) ended for equipment installed after December 31, 2025, so don't let a quote count it as a 2026 saving.
Electricity rates: why efficiency pays in Frisco
In Oncor territory, your rate depends on the retail plan you choose — typical all-in residential rates in the Dallas area run roughly 14–17¢ per kWh, with advertised plans ranging much wider (compare at your real usage on the plan's Electricity Facts Label, via the state's Power to Choose site). CoServ members pay the co-op's set rates instead. Either way, air conditioning is the largest load in a Frisco home — a big two-story house with two systems can see cooling drive well over half of a summer bill — so efficiency tier has an outsized effect on operating cost.
Sizing a system for North Texas heat and humidity
Dallas-area design temperatures sit around 100°F, and Gulf humidity means a system also has to remove moisture, not just heat. An oversized unit short-cycles and leaves the house clammy; an undersized one runs flat-out through August. Don't just match the old nameplate: ask for a Manual J load calculation — especially in Frisco, where builders often sized generously and a right-sized replacement may be smaller than what comes out.
The working rule of thumb in North Texas is 1 ton per 500–600 sq ft for typical construction. Use our cost calculator for a first estimate, then insist your installer confirms sizing with a Manual J load calculation. Also note the federal floor: new split systems installed in Texas must be at least 14.3 SEER2 (13.8 SEER2 for systems 45,000 BTU and larger), and split heat pumps at least 14.3 SEER2.
Frisco HVAC replacement FAQ
How much does it cost to replace an AC unit in Frisco, TX?
Most Frisco homeowners pay $8,300–$14,300 installed per system for a full AC and furnace or heat pump replacement, depending on tonnage and efficiency. Many larger Frisco homes have two systems, so budget per system — replacing both together usually earns better labor pricing than two separate jobs.
Does Frisco require a permit to replace an AC unit?
Yes. Frisco lists AC replacement as permitted work, and a mechanical permit is required. Your TDLR-licensed contractor normally pulls it and includes the fee in the quote — ask for the permit number on your contract.
Can I get a utility rebate in Frisco?
It depends on your address. Frisco is split between Oncor and the CoServ electric cooperative. Oncor addresses can benefit from Oncor's Home Energy Efficiency incentive, which is paid to participating contractors and applied as a discount on your invoice. CoServ currently offers no efficiency rebates. Check your electric bill to see which one serves your home before counting on any incentive.
Why do so many Frisco homes have two AC systems?
Most Frisco homes were built after 2000 and are larger two-story designs. Builders usually installed two smaller systems — one per floor — instead of a single 5-ton unit, because that zones better and keeps duct runs shorter. When one fails, ask whether the second system is the same age; replacing both in one visit is often cheaper than two separate replacements.
Compare costs in nearby cities
See our other Dallas–Fort Worth guides: Plano, Irving, Arlington, Garland. Or go back to the national cost overview.
Get free quotes from Frisco installers
Tell us about your project and local HVAC partners will contact you with itemized quotes. No obligation.